Illustration of a geothermal heating and cooling system that handles multiple loads for a community. Illustration by Sarah Cheney.

Illustration of a geothermal heating and cooling system that handles multiple loads for a community. Illustration by Sarah Cheney.

Imagine a home in which the temperature is always comfortable, yet the heating and cooling system is out of sight. That system performs efficiently but doesn’t require extensive maintenance or knowledge on the part of the owners.

The air smells fresh; you can hear the birds chirping and the wind rustling lazily through the trees. The home shares energy with the earth similar to the way the roots of the trees exchange the essentials of life to their leaves and branches. Sounds comfortable, doesn’t it?

Geothermal heating and cooling makes that vision a reality. Geothermal HVAC (heating, ventilating, and air conditioning) brings a building in harmony with the earth beneath, taking advantage of subterranean temperatures to provide heating in the winter and cooling in the summer.

How Geothermal Heating and Cooling Works

Outdoor temperatures fluctuate with the changing seasons but underground temperatures don’t change as dramatically, thanks to the insulating properties of the earth. Four to six feet below ground, temperatures remain relatively constant year-round. A geothermal system, which typically consists of an indoor handling unit and a buried system of pipes, called an earth loop, and/or a pump to reinjection well, capitalizes on these constant temperatures to provide “free” energy.

(Note that geothermal HVAC should not be confused with “geothermal energy,” the process by which electricity is generated directly from the heat inside the earth. That takes place on the scale of utilities and uses different processes, normally by heating water to boiling.)

The pipes that make up an earth loop are usually made of polyethylene and can be buried under the ground horizontally or vertically, depending on the characteristics of the site. If an aquifer is available, engineers may prefer to design an “open loop” system, in which a well is drilled into the underground water. Water is pumped up, run past a heat exchanger, and then the water is returned to the same aquifer, through “reinjection.”

Diagram of how geothermal HVAC systems work

Diagram of how geothermal HVAC systems work. Illustration from Modern Geothermal HVAC

In winter, fluid circulating through the system’s earth loop or well absorbs stored heat from the ground and carries it indoors. The indoor unit compresses the heat to a higher temperature and distributes it throughout the building, as if it were an air conditioner running in reverse. In summer, the geothermal HVAC system pulls heat from the building and carries it through the earth loop/pump to reinjection well, where it deposits the heat into the cooler earth/aquifer.

Unlike ordinary heating and cooling systems, geothermal HVAC systems do not burn fossil fuel to generate heat; they simply transfer heat to and from the earth. Typically, electric power is used only to operate the unit’s fan, compressor, and pump.

A geothermal cooling and heating system has three main components: the heat-pump unit, the liquid heat-exchange medium (open or closed loop), and the air-delivery system (ductwork) and/or the radiant heating (in the floor or elsewhere).

Geothermal heat pumps, as well as all other types of heat pumps, have efficiencies rated according to their coefficient of performance, or COP. It’s a scientific way of determining how much energy the system moves versus how much it uses. Most geothermal heat pump systems have COPs of 3.0 to 5.0. This means for every unit of energy used to power the system, three to five units are supplied as heat.

Geothermal systems require little maintenance. When installed properly, which is critical, the buried loop can last for generations. The unit’s fan, compressor, and pump are housed indoors, protected from the harsh weather conditions, so they tend to last for many years, often decades. Usually, periodic checks and filter changes and annual coil cleaning are the only required maintenance.

Geothermal HVAC Spreads

Geothermal HVAC systems have been used for more than 60 years in the U.S. and beyond.

They work with nature, not against it, and they emit no greenhouse gases. (As mentioned earlier, they use a smaller amount of electricity to run, because they are coupled in with the earth’s average temperature.)

Geothermal HVAC systems are becoming common features of eco-friendly homes as part of the growing green building movement. Green projects accounted for 20 percent of all newly built homes in the U.S. last year. By 2016, a Wall Street Journal article predicted that green housing will grow from $36 billion a year to as much as $114 billion. That’s approaching 30 to 40 percent of the entire housing market.

But a lot of information out there on geothermal heating and cooling is based on outdated information, or outright myths. In our new book Modern Geothermal HVAC Engineering and Control Applications (Egg/Cunniff/Orio -McGraw-Hill 2013), co-authors Greg Cunniff, Carl Orio and I bust many of these myths.

Geothermal HVAC Myths Busted

1.     Geothermal HVAC systems are not considered a renewable technology because they use electricity.

Fact: Geothermal HVAC systems use only one unit of electricity to move up to five units of cooling or heating from the earth to a building.

2.     Photovoltaic and wind power are more favorable renewable technologies when compared to geothermal HVAC systems.

Fact: Geothermal HVAC systems remove four times more kilowatt-hours of consumption from the electrical grid per dollar spent than photovoltaic and wind power add to the electrical grid. Those other technologies can certainly play an important role, but geothermal HVAC is often the most cost effective way to reduce environmental impact of conditioning spaces.

3.     Geothermal HVAC needs lots of yard or real estate in which to place the polyethylene piping earth loops.

Fact: Depending on the characteristics of the site, the earth loop may be buried vertically, meaning little above-ground surface is needed. Or, if there is an available aquifer that can be tapped into, only a few square feet of real estate are needed. Remember, the water is returned to the aquifer whence it came after passing over a heat exchanger, so it is not “used” or otherwise negatively impacted.

4.     Geothermal HVAC heat pumps are noisy.

Fact: The systems run very quiet and there is no equipment outside to bother neighbors.

A technician inspects a geothermal HVAC air handler

A technician inspects a geothermal HVAC air handler. Photo courtesy of Jay Egg

5.     Geothermal systems eventually “wear out.”

Fact: Earth loops can last for generations. The heat-exchange equipment typically lasts decades, since it is protected indoors. When it does need to be replaced, the expense is much less than putting in an entire new geothermal system, since the loop or well is the most pricey to install. New technical guidelines eliminate the issue of thermal retention in the ground, so heat can be exchanged with it indefinitely. In the past, some improperly sized systems did overheat or overcool the ground over time, to the point that the system no longer had enough of a temperature gradient to function.

6.     Geothermal HVAC systems only work in heating mode.

Fact: They work just as effectively in cooling and can be engineered to require no additional backup heat source if desired, although some customers decide that it is more cost effective to have a small backup system for just the coldest days if it means their loop can be smaller.

7.     Geothermal HVAC systems cannot heat water, a pool, and a home at the same time. Fact: Systems can be designed to handle multiple loads simultaneously.

8.     Geothermal HVAC systems put refrigerant lines into the ground.

Fact: Most systems use only water in the loops or lines.

9.     Geothermal HVAC systems use lots of water.

Fact: Geothermal systems actually consume no water. If an aquifer is used to exchange heat with the earth, all the water is returned to that same aquifer. In the past, there were some “pump and dump” operations that wasted the water after passing over the heat exchanger, but those are exceedingly rare now. When applied commercially, geothermal HVAC systems actually eliminate millions of gallons of water that would otherwise have been evaporated in cooling towers in traditional systems.

10.  Geothermal HVAC technology is not financially feasible without federal and local tax incentives.

Fact: Federal and local incentives typically amount to between 30 and 60 percent of total geothermal system cost, which can often make the initial price of a system competitive with conventional equipment. Standard air-source HVAC systems cost around $3,000 per ton of heating or cooling capacity, during new construction (homes usually use between one and five tons). Geothermal HVAC systems start at about $5,000 per ton, and can go as high as $8,000 or $9,000 per ton. However, new installation practices are reducing costs, to the point where the price is getting closer to conventional systems under the right conditions.

Factors that help reduce cost include economies of scale for community, commercial, or even large residential applications and increasing competition for geothermal equipment (especially from major brands like Bosch, Carrier, and Trane). Open loops, using a pump and reinjection well, are cheaper to install than closed loops.

Thanks for the thousands of likes and hundreds of comments!  National Geographic has closed comments for this blog.  Please continue the conversation and get the answers you need for geothermal heating and cooling on Jay Egg’s blog, “Geothermal Heating and cooling Questions and Answers

Jay Egg is the co-author of the new book Modern Geothermal HVAC Engineering and Control Applications (McGraw-Hill 2013), with Greg Cunniff and Carl Orio. He co-wrote the book Geothermal HVAC, Green Heating and Cooling in 2010 with National Geographic’s Brian Clark Howard. Jay consults with the geothermal HVAC industry. He previously served as an installer of the technology through his company EggGeothermal.


  1. Jay Egg
    November 30, 2015, 5:13 pm

    Ramesh in Bengaluru, India,
    I am pleased that you are seeking advice for geothermal HVAC in one of your shopping malls. Earth coupling has many variations depending upon lithology and geology, as well as climate zones. This article-blog gives some of the guidance that will help you along the way. Please review it and let us know if it helps.

  2. Ramesh Babu TR
    November 25, 2015, 5:36 am

    Hi Jay,
    Would request your expert advise on the Geo thermal HVAC system being proposed for one of our shopping malls. Need to understand the concept of the Earth loop cooling system & how can we improvise on the a proper heat exchange system.


  3. Deborah Stotelmyer
    Maryland, USA
    November 18, 2015, 1:56 pm

    Thanks so much for this article! My father was a water well driller who installed one of these systems, years ago in his large home on the Eastern Shore, Kent Island. I’ve been researching ways to heat/cool our home efficiently, and couldn’t remember enough of the information I needed, and my dad is no longer with us.

  4. Jay Egg
    November 12, 2015, 8:05 am

    Sam in Miami,
    There are variations of running geothermal from storage tanks, but they all necessarily have an on demand source to replenish water when is becomes too warm or too cool. The answer is that you will need a well, and Caribbean hydro-geology is acceptable in my experience. I was involved in a large community-wide project in Abaco that had impressive results.
    I recommend that you review this article: …and perhaps pick up a book on the subject, such as “Modern Geothermal HVAC…” .
    By all means, keep me updated on your progress at .

  5. Sam
    Miami, FL
    November 10, 2015, 11:06 am

    Hi Jay,

    I am a total Geothermal newbie- Is it possible to run a geothermal A/C off a Cistern? If yes what size of a cistern tank would be needed? Also if it’s not possible how do I find out if I have well water under me? I live on an Island in the Caribbean and cooling is very expensive, looking for immediate alternatives.

    Thank you,

  6. James King
    Chesapeake, VA
    November 2, 2015, 8:32 pm

    In the last five years I had my old water source heat pumps replaced using my existing well and pump. I am getting a little edgy about the pump and I am wondering if it is possible to install an aftermarket underground closed loop system to replace the pump and well only and, of course, use my existing heat pumps. I live on the edge of a salt water river with sandy soil underneath the surface of the land.

  7. Jay Egg
    October 30, 2015, 6:14 am

    Brad in Odessa, WA
    Thank you Brad! I know of the attention to detail that Spectrum puts into their products; I’d be hard pressed to find better than your fine establishment. Keep up the great work; you do remarkable work in the Geothermal Heat Pump industry!

  8. Brad Walter
    Odessa, W.A.
    October 27, 2015, 2:24 pm

    Great Stuff Jay, keep up the good work and supporting the Geothermal Industry it’s truly fantastic. It’s so sad to hear some of these horror stories as it tells us that we need to keep track of dealers and installers in this Industry that have no place installing Ground Source Heat Pumps. Geothermal Installations need to be very meticulous and professional. There is not a lot of room for error.

    Many Thanks!

    Brad Walter
    Manufacturer Representative
    Spectrum Manufacturing LLC
    2194 N Schoonover Rd
    Odessa Washington 99159

    Phone: 509.988.3220
    Fax: 509.982.0041


  9. Jay Egg
    September 30, 2015, 4:35 am

    Paul in Fort Worth,
    I recommend that you read through this piece in the National Geographic Energy Blog entitled, “The “One-Two” Punch for Net-Zero in DC Home; Power and Carbon Neutral” . Don’t let the title fool you; it has a ton of good information about the costs of going geothermal using vertical drilling. You may even find the rest of the article intriguing.
    As far as incentives, you are likely eligible for the 30% federal tax credit (almost everybody is). This link will help you to determine the other local incentives for which you may be eligible. Be sure to watch the tutorial video!
    Lastly, if you want a good handbook/guide, consider picking up a book such as, “Modern Geothermal HVAC Engineering…” from McGraw-Hill . It’s always nice to be armed with good information.
    Let me know if this has helped you?

  10. Paul
    Fort Worth, tx
    September 21, 2015, 11:07 pm

    Hi Jay,
    OK, I need to check into this! I have a friend who installs these systems. What would be the approximate cost of a closed loop, multi-well (I know it will require that) system or heat and cool approximately 2300 square feet in North Texas climate. Hot summers and mild winters. This is new construction, not yet started, on 1 acre. Rebates? Pair with photo panels? Advice?